Induction heater 1.5KW

Applicable in the automotive, railway and shipbuilding industries, metalworking and maintenance
Applicable in areas where speed and flexibility are required and there is a risk of damage by open flame around hot parts (upholstery, rubber sleeves, electrical installations, etc.)
Makes it easier to remove rusted screws and old parts, preheat exhaust pipes, screws, nuts, bearings, tools before hardening, gluing, soldering and is ideal for defrosting
Voltage 220V, 50 Hz
Power cord 1.5 m
Coil heater cord 0.8 m
Power 1.5 kW / 3.2 kVA
Consumption 8 A
Do not exceed the duty cycle DIH-1.5kW - 2 minutes heating (on) and 2 minutes cooling (off)
Protection code IP20
Operating frequency 25 - 65 kHz, automatic adjustment
Protection class I
Fan cooling
PF (power factor) 0.99 (PFC)
Protection against overheating and overload and coil short circuit
Heating without flame and sparks
Dimensions 210 x 140 x 90 mm
Weight 4.6 kg
12 months warranty
 
Extension cables - if necessary, you can only use the following extension cables:
up to 5 m with a diameter of 2.5 mm2
up to 15 m with a diameter of 4 mm2
When using the device with an alternative power source - e.g. When using a mobile power generator, it is necessary to use a quality device
Use a generator with a power of at least 3-4 kW, or a DC/AC converter with a power of 2-3 kW and only with a sine wave - do not use a converter with a square or quasi-sine wave
If you do not comply with the above requirements, the device may be damaged and the warranty will be void